SS 10014 Distributed I/O device in 6 DIN module box 4 inputs for RTD over RS-485
The device SS10014 converts up to 4 analogue input signals into engineering units in digital format.
The data are transmitted with MODBUS RTU/ASCII protocol over the RS-485 network. It is possible to connect on input RTD, Potentiometer or Resistance sensors.
The device guarantees high accuracy and stable measure versus time and temperature.
To ensure the plant safety, a Watch-Dog timer alarm is provided. The isolation between the parts of circuit removes eventual ground-loop effects, allowing the use of the device even in the heavy environmental conditions.
The device is housed in a 6 module DIN rough self-extinguishing plastic box for mounting on EN-50022 standard DIN rail.
- Modbus Slave device on RS-485
- Modbus RTU/ Modbus ASCII protocol
- 4 input channels
- Input configurable for RTD, Resistance and Potentiometer
- Communication parameters configurable by dip-switches
- Watch-Dog Alarm
- Remotely Configurable
- 1500 Vac 3-ways Galvanic Isolation
- LEDs of signalling on front side for power supply and communication
- Connection by removable screw terminals
- High Accuracy
- CE mark
- DIN rail mounting in compliance with EN-50022
Manuals and guides
|Maximum current consumption||45 mA @ 24 VDC|
|Communication protocol||Modbus ASCII, Modbus RTU, Modbus TCP (using SS10580 converter)|
|Insulation voltage||1500 Vca @ 50 Hz for 1 minute between inputs, outputs, serial and supply|
|EMC Immunity||conform to EN 61000-6-2|
|EMC Emissions||conform to EN 61000-6-4|
|Supply voltage||from 10 to 30 VDC|
|Polarity inversion protection||maximum 60 VDC|
|Humidity||operating environment from 0 to 90 % (non condensing)|
|Storage temperature||from -40 to +85 ºC (without ice)|
|Mounting||on EN-50022 DIN rail|
|Weight||about 200 g|
|Temperature||operating environment from -10 to +60 ºC|